Create a life of freedom and adventure

We fix a BIG design flaw with sprinter vans by fixing our sprinter side trim to make it waterproof.

To fix the small rust chips on the outside of our vehicle, we tackle some rust repair, but bad rust repair. This is what not to do.

With our van empty, we need to do rust repair on our vehicle to fix all the rust spots and make them shiny and new again.

To start our van conversion, we need a blank slate, so on with the van conversion deep cleaning we go after removing the floor and seen the amount of dirt under there.

To clean our sprinter sliding door step, we explain how to remove the sliding door step, clean the step and put the sliding door step back on.

We explain how to remove the floor of our van to start our van conversion. Honestly, I swear the bolts holding in this floor are near impossible to remove without a hammer…

Day 1 of our Sprinter/Crafter Van Conversion! Today’s first task, strip the van of all its plywood. To figure out what we’re truly getting ourselves into. We need to strip the van down to its bare metal and remove the existing plywood van lining and metal bulkhead.